A GUIDE TO VINTAGE STAR WARS FIGURES & ACCESSORIES

Endor Blaster

TABLE OF CONTENTS

The Endor Blaster was usually released with the following combinations of colour to figure:

Grey/Grey-Blue Endor Blaster:

Black Endor Blaster:

There are 4 main mould variations. Subvariants do exist and may not all be documented. As a result of the fact that these were shot on a sprue tree in higher numbers the subvariants may vary heavily depending on the steel mould used.

MOULD COMPARISON: M1, M2, M3 & M4

M1: COLOUR COMPARISON

UNITOY

M1 was produced by UNITOY in Hong Kong and can come in two main colors:

  • bluesih grey
  • grey

M2: COLOUR COMPARISON

UNIVERSAL MANUFACTURERS

M2 was produced by UNIVERSAL MANUFACTURERS in TAIWAN and can come in three main colors:

  • dark grey
  • very dark grey
  • very dark bluesih grey

M3: COLOUR COMPARISON

SMILE

M3 was produced by SMILE in Hong Kong and can come in two main colors:

  • blue
  • black

 

M4: COLOUR COMPARISON

KADER

M4 was produced by KADER in Hong Kong and can come in three main colors:

  • grey-blue
  • blue-grey
  • black

 

GW ACRYLIC ENDOR BLASTER DISPLAY CASE

Easy to use, the Endor Blaster accessory holder is supplied in 2 parts – BASE and TOP PLATE – and are specifically designed to accompany the GW Acrylic LASER cases

All holders are produced from Archival grade UV acrylic sheet (UV 99%+) to ensure the very best protection for your collection. 

We like to access our collectibles and have the freedom to change things up therefore we recommend Bostik Removeable Glue Dots which are acid and lignin free and leave no trace on the surface of the case when removed.

> Check out the new accessory holder range over at the GW ACRYLIC site

Reproductions

Coming soon