Yoda Snake
The Yodfather
TABLE OF CONTENTS
Temporary version until Wolff redoes in VV format
Yoda’s Snake was released with the following combinations of colour to figure:
Orange and Brown Snake:
There are 4 main mould variations plus subvariants. More subvariants may exist. As a result of the fact that these were shot on a sprue tree in higher numbers the subvariants may vary heavily depending on the mould used.
Mould COMPARISON: M1, M2 & M3
Easy to use, the Yoda snake accessory holder is supplied in 2 parts – BASE and TOP PLATE – and are specifically designed to accompany the GW Acrylic LASER cases.
All holders are produced from Archival grade UV acrylic sheet (UV 99%+) to ensure the very best protection for your collection.
We like to access our collectibles and have the freedom to change things up therefore we recommend Bostik Removeable Glue Dots which are acid and lignin free and leave no trace on the surface of the case when removed.
> Check out the new accessory holder range over at the GW ACRYLIC site
Yoda Figure Guide
Yoda Snake Guide
Yoda Cane Guide
Yoda Belt Guide
Yoda Cloak Guide
Lili Ledy Yoda Guide
Top Toys Yoda Guide
Poch Yoda Guide
